SICK CLV490 Betriebsanleitung PDF herunterladen (Seite 234)

Chapter 10 Operating Instructions

CLV490 Bar Code Scanner

Appendix

– Angle gamma: 0 degrees (Divergence of the scanner (reading windows) from the

perpendicular in the plane askew to the direction of feed)

¾ Set the following parameters in the C

OORDINATES section:

– X coordinate: Measure the distance from the pulse photoelectric switch to the

CLV490’s reading window perpendicular!

(x offset + x coordinate = the distance from the pulse photoelectric switch to the

CLV490’s reading window perpendicular)

– Y coordinate: 300 mm (11.8 in) (The middle of the CLV490 to the left edge of the

conveyor belt in the direction of convoyer belt)

– Z coordinate: 1,400 mm (55.2 in) (Height of the CLV490 above the conveyor belt)

¾ Close the S

CANNER POSITION PARAMETERS tab.

3. Set the reading pulse source: D

EVICE CONFIGURATION tab

¾ In the R

EADING TRIGGER MODE section click the option Sensor Input (Active High).

¾ In the Output on Good read section click the option End of label.

¾ Close the tab.

Fig. 10-51: Parameterization example: Settings on the "Device Configuration" tab

1 2 ... 229 230 231 232 233 234 235 236 237 238 239 ... 269 270

Keine Kommentare

SICK CLV490 Betriebsanleitung Seite 234