SICK ICR890 Betriebsanleitung PDF herunterladen (Seite 81)

Operating Instructions Chapter 6

ICR890

Operation

6.3.1 Overview of the configuration procedure

• Connect data interfaces of the PC and the ICR890 System/MSC800

• Start the SOPAS-ET Configuration Software and create a new project file

• Configure the scan assistant (activate PC communication)

• Establish communication with the ICR890 System/MSC800

• Accept current configuration of the ICR890 System/MSC800 in the project tree

• Use the password “client“ to register at the system as an “authorized client“

• Configure the ICR890 System/MSC800 for use

• Activate the image output of the SOPAS-ET Configuration Software (“Image Viewer“) to

check the reading

• If necessary, apply the diagnosis tools “Reading Diagnosis“ and “Event Monitor“

(online presentation/recording of the switching statuses of switching inputs and

outputs as well as data transfers to the host)

• Load the optimized configuration into the ICR890 System and save permanently

• Save the project file with the configuration data of the ICR890 System/MSC800 at the

6.3.2 Establishing communication with the ICR890 System/MSC800

Prerequisite The TCP-IP protocol at the PC has to be active to enable communication via TCP-IP.

Connecting data interfaces

¾ Interconnect the PC and the ICR890 System/MSC800 according to Tab. 6-2.

Connection via: At data interface: Comment

MSC800 ETHERNET 1

(10/100 MBps)

Connect the PC (Ethernet interface), MSC800 (ETHERNET 1

connection) and the ICR890 System (HOST ETHERNET connection) to

a joint switch using a patch cable no. 6030928 (10 m (32.8 ft)) or

no. 6029630 (3 m (9.84 ft)) for each connection.

MSC800 (optional) AUX 1 or HOST 1

(RS 232)

Connect the PC via a 3-wire null modem cable no. 2014054 to the

9-pole D-Sub connector AUX 1 of the MSC800.

ICR890 System HOST ETHERNET

(10/100 MBps)

Directly connect the PC (Ethernet interface) to the HOST ETHERNET

connection of the ICR890 System via a crossover cable.

- or -

Use the patch cable (1:1) no. 6030928 (3 m (9.84 ft)) or no.

6029630 (10 m (32.8 ft)) when connecting via a hub.

ICR890 System (optional) AUX or HOST

(RS 232)

Provide the cable no. 6028420 (open end) for connection to the PC

with a 9-pole D-Sub socket and, depending on the interface type,

configure it as a null modem cable.

(For wire colour assignment: see Tab. 5-31, page 75, transmitter and

receiver signals are crossed, see Fig. 5-6, page 66).

Connect the PC via the cable no. 6028420 to the AUX connection or

the ICR890 System HOST.

Tab. 6-2: Connection between the PC with the SOPAS-ET Configuration Software and the ICR890 System/MSC800

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 127 128

Kommentare zu diesen Handbüchern

Keine Kommentare

SICK ICR890 Betriebsanleitung Seite 81

Kommentare zu diesen Handbüchern